reinforced a void in my formal dining table

[beebeenator]

http://img35.imageshack.us/img35/352/pic100612003.jpg

This is the void

http://img535.imageshack.us/img535/4585/pic100612002.jpg

and this is the glass that covers it

http://img535.imageshack.us/img535/49/pic100612004.jpg


Reinforcing it to make sure the glass has enough support when a glass lazy susan is installed. I opted not to make a wooden lazy susan since it seems wiser to use glass anyways

http://img291.imageshack.us/img291/7184/pic100612005.jpg

[beebeenator]

http://img291.imageshack.us/img291/1599/pic100612006.jpg

thank God for router and pattern bits!

http://img535.imageshack.us/img535/3849/pic100612007.jpg

my chiseling has improved

http://img541.imageshack.us/img541/5407/pic100612008.jpg

so has my marking and alignment

http://img291.imageshack.us/img291/3544/pic100612009.jpg

[beebeenator]

http://img35.imageshack.us/img35/4485/pic100613002.jpg

http://img155.imageshack.us/img155/957/pic100613001.jpg

all lap joint markings were done in actual and on the fly

http://img256.imageshack.us/img256/7140/pic100613003.jpg

these were done freehand with a router. Its about time i make a dado jig !

http://img291.imageshack.us/img291/7986/pic100613004.jpg

nice and snug

[timber715]

nice work so far Ben, were you able to use the kerfmaker in this application?

[beebeenator]

yep i did. but not in the way that it was really intended to :)

i used it as a memory stick of sorts instead. hehehe

Normally any dadoing will be done in my cross cut sled/TS and since i only have a normal blade i just go for several passes, the kerf maker wouldve been perfect. But i still havent made a crosscut sled for the jimmy jig on my ts... :(